Define the window
Material certificates, temper, surface condition and the permitted bonding window are reviewed together.
Wantuo / Advanced clad materials · China
Built in layers.
Wantuo joins corrosion-resistant alloys to structural metals for pressure equipment, heat transfer and demanding process service worldwide.
Explore material systemsEngineered interface
verified bond
verified bond
70+Qualified pairings
9.0 mPlate length
100%UT mapping
ASTM A263ASTM A264ASTM A265ASTM B898EN 13445 projectsASME Section II
ASTM A263ASTM A264ASTM A265ASTM B898EN 13445 projectsASME Section II
01 / Material matrix
Start with the service condition.
Choose what the equipment must resist. The matrix shows a practical starting system; final chemistry, thickness and heat treatment are confirmed against the purchaser’s specification.
SYSTEM / WT–02
Titanium + pressure-vessel steel
A commercially pure titanium working face provides chloride resistance while normalized carbon steel carries the vessel load.
CladdingBond interfaceBacking metal
02 / Bonding route
One interface.
Four controls.
Explosion bonding is fast. Qualification is deliberate. Each plate travels through a controlled route that protects the interface from raw material release to the final dossier.
Set the geometry
Stand-off, flyer angle and charge distribution are calculated for the selected metal pairing and plate area.
Stabilize the plate
Flattening, edge removal and heat treatment are sequenced to manage residual stress and dimensional tolerance.
Map the bond
Ultrasonic coverage, mechanical coupons and full material traceability close the manufacturing record.
03 / Working envelope
Large format.
Close control.
Wantuo supplies bonded blanks, finished plate and near-net-shape components from its integrated manufacturing base in China. The figures below are a typical envelope, subject to alloy pairing and engineering review.
Maximum bonded format2,800 × 9,000 mm
Backing thickness8–180 mm
Cladding thickness0.8–18 mm
Supply statesPlate / block / ring
04 / Evidence pack
Proof travels with the plate.
Every order closes with a documentation set shaped around the inspection and test plan—not a generic certificate bundle.
AIdentity and traceability+
Heat numbers remain linked through cutting, bonding and finishing.
- EN 10204 3.1 material certificates
- Incoming PMI where specified
- Transfer marking and final plate map
BBond integrity+
The interface is checked against the governing standard and purchaser-specific acceptance criteria.
- 100% ultrasonic examination
- Bond coverage map
- Shear, bend and tensile coupons as required
CFinal release+
Dimensional records and release documents are consolidated for fabricator handover.
- Final dimensions and flatness
- Heat-treatment charts
- Third-party inspection access
05 / Project brief
Give engineering a clean starting point.
Select the application and supply form, then add the dimensions you already know. The builder prepares a concise requirement you can take to our dedicated enquiry page.
Open the enquiry desk